Quick Guide: Replacing a TVMS Fuse

If there is a blown fuse warning on the control panel, the corresponding fuse in the TVMS will need to be replaced.

1. Turn the van system off at the control panel. Check the washers are off to ensure this has been done correctly. 

2. Go to the TVMS at the rear of the vehicle. The TVMS is pictured below.

3. Locate the blown fuse. There will be a white indicator light above the blown fuse. 

4. Remove plastic cover from the TVMS.

5. Remove the blown fuse using the plastic tweezers found inside the plastic cover. The blown fuse can be thrown away.
6. Replace the blown fuse with one of the spare inline fuses. The replacement fuse MUST be of the same colour as the blown fuse.

7. Close the plastic cover back over the fuses.

8.Turn the system back on at the control panel.